skin 55
- Rear floor shutoff skin and transponder antenna hole cover
- Installing Instrument Panel & Prepping Fuel Selector
- Closed the Top Front Skin
- Door latches
- Installing back side skin
- Routing misc wires and fluid lines
- Side panel upholstery and floor doubler
- Front inner skin
- Preparing for top front skin installation
- Rear fuselage: pulling rivets
- Side skin misc: sound proofing and air channel sealing
- Rear fuselage: covering the remaining top skin
- Side skin part 3
- Side skin continued
- Starting to install side skin
- Fitting control rods & prepping side skin
- Center fuselage connection and bottom floor skin
- Center fuselage: ribs and floor skin
- Rear fuselage: covering (half of) the top skin
- Rear fuselage: Misc work before closing the top skin
- Rear fuselage: a problem with luggage floor skin
- Rear fuselage skin & fixing a damaged inner skin
- Rear fuselage rib assembly
- Remaking left landing light cover - Part 2
- Left tank, part 1 (Sealing ribs and skin)
- Left tank match drilling, left wing root trailing edge
- Left wing skin misc clean up, and discussing panel with MPB
- Remaking left landing light cover - Part 1
- Left wing: landing light cover and fuel level sender
- Mocking left tank and filling rivets
- Prosealing the right fuel tank, left wing leading edge & lights
- Left top skin, and landing lights
- Right leading edge and fuel tank prep
- Right leading edge done
- Left bottom skin riveted
- Left bottom skin clecoed, and some rivet drilling
- Right aileron, flap, trailing edge, and left spar
- Right leading edge skin damage
- Right leading edge done
- Right top skin and leading edge
- Rib 9 fix, and starting right top skin
- Working on right top skin and left ribs
- Right bottom skin riveted
- Right bottom skin fitting and an successful experiment
- Right spar assembly 4 complete, started assembly 3
- Elevator tip forming and shortening rivets
- Elevator bottom skin, and trim motor hardware
- Elevator skin fitting and safety wire
- Elevator skin prep and inspection hatch
- Vertical stabilizer rib1 and skin work
- Vertical stabilizer spar riveting
- Horizontal Stabilizer Close
- HS skin dimple and cleco
- HS skin dimple attempt
- HS spar riveting and skin prep (kinda)