TLDR Closed Center Channel on the Rear Passener Row Installed USB Power Installed Music Plug Adjusted M4 holes for Cover Plates Installed Carpet on Cover Plates ...

TLDR Made a jig to carry the wing for easier mounting Made some “bullets” from sacrifacial AN7 bolts Details Wing Jig Inspired by a fellow builder, I decided to make a jig to carry the wi...

TLDR Re-installed the safetywire on the propeller locking plate Reorganized and secured wiring in the engine bay Oil Purge Details Safety Wire My A&P friend Brian came by yesterday ...

TLDR Installed the propeller Details Intalled the airmaster propeller today. Most of the process was very smooth, but I ran into a small hiccup and had to re-install the #2 blade twice. Gre...

TLDR Swapped out the throttle quadrant cover Installed carpet under rudder pedal Details Throttle Qudrant Cover I have been using the factory provided throttle quadrant cover since I buil...

TLDR Tightened all oil lines before oil purge WIP install the air filter Details Tightened up most oil lines I tightened the remaining oil lines with exception of the ones that need to be...

TLDR CLeared out an empty crate Tightened up oil line under engine Tightened up exhaust pipe Details Cleared out empty crate As more and more parts are moved from the parts crate to the...

TLDR Fixed a leak in brake reservior Installed intercooler baffle gasket Adjusted cowling gap to propeller flange Details Brake Reservior Leak I recently noticed a small leak in the bra...

TLDR Reinforced the cowling tip with fiberglass & epoxy Installed heat shield on the lower cowling Details Fiberglass & Epoxy As I mentioned in a previous blog, my cowling’s gap t...

TLDR Spent 2.5 hours to install the tail control covers Details Way back from when I built the vertical stablizer, there are a row of rivnuts on each side of the vertical stablizer. Today I...